INSTALLER TO INSURE THAT VOLTAGE OF RETROFIT ASSEMBLY IS THE SAME VOLTAGE AS THE UNIT
TO BE RETROFITTED.

INSTALLER INSURE THAT WIDTH OF HOUSING IS BETWEEN 3-3/4" AND 7-1/2".

TURN OFF POWER TO FIXTURE BEING RETROFITTED.

REMOVE EXISTING LAMPS.

REMOVE EXISTING BALLAST/WIREWAY COVER(S).

CUT BALLAST BLACK & WHITE LEADS WITHIN 8 TO  8 INCHES OF BRANCH CIRCUIT CONDUCTORS.

REMOVE EXISTING LAMP HOLDERS, SOCKET PLATES AND END CAPS.

REMOVE BALLAST AND DISCARD IN ACCORDANCE WITH LOCAL CODES AND/OR HAZARDOUS MATERIAL
REQUIREMENTS.

ATTACH MOUNTING ANGLES USING PROVIDED "TEK" SCREWS. INSURE BRACKET IS APPROXIMATELY
1 INCH FROM THE END (USE YOUR THUMB AS A GUIDE).

CONNECT THE POWER SUPPLY WIRES TO THE BLACK AND WHITE LEADS ON THE RETROFIT ASSEMBLY
BALLAST USING PROVIDED WIRE NUTS. CONNECT BLACK TO BLACK AND WHITE TO  WHITE.

USING THE PROVIDED "TEK" SCREWS SECURE RETRO-KIT TO THE MOUNTING BRACKETS BY
SCREWING THROUGH THE HOUSING SLOTS.

ONCE RETROKIT IS INSTALLED ATTACH END PLATE AND SECURE WRAPAROUND LENS.

INSTALL LAMPS AND TURN ON POWER.